Cequent Performance Products 76192 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Existing weldnuts
Fasteners typical both sides
Figure 1
1. Trim bumper fascia – Measure to find the center of the fascia, mark a centerline on the bottom of the fascia and trim as shown in
Figure 2. Mark a centerline on the vertical portion of fascia and trim as shown in Figure 3 * Do not trim away the bottom edge.
*Dimensions are approximate and may be adjusted for fit and aesthetics*
2. Lower exhaust and remove existing fasteners – Lower the exhaust by removing (2) bolts from each rear exhaust hanger bracket (1
per side) with a 13mm socket. Remove (4) M10x1.5x40mm bolts from the outside of the frame rails (2 per side) with a 16mm socket.
3. Install hitch – Raise the hitch into position over the exhaust and forward enough so that the receiver clears the bottom edge of fascia.
Align the holes in the hitch with the vehicle existing weldnuts and install the bolts removed earlier.
4. Torque fasteners - Tighten the M10 fasteners with torque wrench to 53Lb.-Ft. (72 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5. Re-install exhaust - Raise exhaust into position, install the bolts removed from the hangers earlier.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch
or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2017 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76192, 84192, CQT76192
Frame rail
Existing fasteners
(M10x1.5x40mm
Hex flange bolts)
Figure 2 Bottom View
Figure 3 Rear View
Leave the bottom edge!
Sheet 3 of 15 76192NP 9-8-17 Rev. A