Nikon RetinaStation Manual Del Usuario página 9

RetinaStation
User Manual
Product Compliance
Guidance and manufacturer's declaration – electromagnetic emissions
The RetinaStation is intended for use in the electromagnetic environment specified below. The customer or the
user of the RetinaStation should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage
fluctuations/flicker
emissions
IEC 61000-3-3
93/42/EEC/M5 Medical Device Directive
Indicates this equipment contains Type B applied parts
The RetinaStation is classified as follows:
Class I Equipment – Protection against electrical shock.
Type B – Degree of protection against electric shock of applied part (chin and forehead rests).
Ordinary Equipment (IPX0) – Degree of protection against ingress of liquids (none).
Continuous Operation – Mode of operation
Electromagnetic Compatibility (EMC): EN 60601-1-2
The RetinaStation device has been tested to comply with the emission and immunity
requirements of EN60601-1-2. The RetinaStation is intended for use in an electromagnetic
environment where radiated RF disturbances are not beyond the standard defined in
EN60601-1-2.
Certification: Under IEC 60601-1
Compliance
Group 1
Class A
Class A
Complies
Electromagnetic environment – guidance
The RetinaStation uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference to nearby electronic equipment.
The RetinaStation is suitable for use in all establishments,
including domestic establishments and those directly connected to
the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Page 7 Ver. B
English (en)