Festo DSMI-B Serie Instrucciones De Utilizacion página 34

DSMI-...-B
• Connect the measuring system to the connecting cable
as described in the description of the positioning controller.
The PIN assignment is shown in the table below:
Pin Designation
1 DC +10 V
2 Signal
3 GND
4 Screen
1)
Terminating resistor: 5 kΩ
Linearity: ±0.25 %
Fig. 20
For interrogation of the end positions
with DSMI-12 ... 40-B:
• Place the proximity switch (B)
SME/SMT-10F-...-KL on the groove
of the shock absorber retainer.
A sensor bracket (D
required to fasten the proximity switch.
The proximity switch is actuated by
magnets (C) in the stop lever.
For interrogation of the end positions
with DSMI-63 ...-B:
• Place the SME/SMT-8..-... proximity
sensor (B) in the sensor bracket
(E
The proximity sensor is actuated by
magnets (C) in the stop lever.
34
1)
Accessories) is
Accessories).
Assignment
3
2
(D) (B)
Fig. 21
(B) (E)
Fig. 22
Festo DSMI-...-B 1210b English
1
4
(C)
(C)