Metra AX-SUB28SWC-6V Instrucciones De Instalación

Instrucciones de instalación para AX-SUB28SWC-6V
AX-SUB28SWC-6V
(with 6.2" screen, without NAV)
Subaru
2015-up
INTERFACE FEATURES
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Retains the factory backup camera
• Retains the factory AUX-IN jack
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Includes the AX-CAM6V 12-volt to 6-volt converter
INTERFACE COMPONENTS
• AX-SUB28SWC-6V harness • AX-CAM6V 12-volt to 6-volt converter
APPLICATIONS
SUBARU
Forester 2016-up
Impreza 2015-up
Legacy 2015-up
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
1-800-221-0932
REV. 12/15/16 © COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
Outback 2015-up
WRX 2016-up
WRX (with NAV) 2015
XV Crosstrek 2015-up
metraonline.com
Installation Instructions for AX-SUB28SWC-6V
Connections to be made
• Connect the Black wire to chassis ground, and also to the Black wire of the AX-CAM6V.
• Connect the Red wire labeled "Camera Power 6V" to the Blue/Red wire of the AX-CAM6V.
• Connect the unlabeled Red wire to accessory power.
• Connect the Green/Purple wire to the reverse wire of the aftermarket radio,
and also to the Blue/White wire of the AX-CAM6V.
To the aftermarket radio:
• Connect the Yellow RCA jack to the backup camera input.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the AUX input.
The following (2) wires are for aftermarket multimedia/navigation radios that require
these wires:
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the speed sense wire.
Installing the AX-SUB28SWC-6V
With the key in the off position:
• After the radio has been tested and working, connect the AX-SUB28SWC-6V harness
to the vehicle, and then into the ASWC-1.
• Refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
K P
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
1-800-221-0932
REV. 12/15/16 © COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
OWER
Metra recommends MECP
certified technicians
metraonline.com