Metra AX-ADMZ01 Instrucciones De Instalación

AX-ADMZ01
The AX-ADMZ01 is designed to and must be used with the AX-ADBOX1 or
AX-ADBOX2 (sold seperately). Please refer to AX-ADBOX1 or AX-ADBOX2
for 16-pin connector instructions.
applIcatIons
maZda
CX-7
CX-9
Interface components
• 22- to 24-way harness
tools requIred
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
METRA. The World's best kits.
Installation Instructions for AX-ADMZ01
2007-up
2007-up
™ 1-800-221-0932
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
WIrInG tHe aX-admZ01
from the 16-pin harness with stripped leads (included with interface)
• Connect the White wire to the left front positive speaker output of the aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output
of the aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output
of the aftermarket radio.
Only make the following connections if the vehicle is amplified.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the purple wire to the radio's right rear positive speaker output.
• Connect the purple/Black wire to the radio's right rear negative speaker output.
Note, the following wires are not used in this application:
• red, light Green, Blue/pink, Green/purple.
from the 24-way connector:
• Connect the Black wire to the radio's ground wire.
• Connect the red wire to the ignition wire of the aftermarket radio.
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the orange wire to the illumination wire of the aftermarket radio.
If the aftermarket radio has no illumination wire, tape off the orange wire.
• Connect the Blue wire to the radio's antenna turn on wire.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION