Lighting Instructions - RealFlame 11802 LP El Manual Del Propietario

Using a Long Match or Lighter
1. Prior to lighting, use a shovel to move crushed glass for access to the burner.
2. Wearing heat resistant gloves, position the burning long match or burning butane
lighter near the side of long match or burning butane lighter near the side of
the burner. DO NOT lean over the fire column while lighting!
3. Turn control knob counterclockwise to "LIGHT".
4. Remove long match/long butane lighter.
5. After lighting, use a shovel and heat resistant gloves to carefully move the crushed glass back
into the proper position and replace the glass panel.
6. After lighting, rotate the Burner Control Knob counter clockwise to "Low" setting. Observe
flame, make sure all burner ports are lit. Flame height should be no higher than 13 inches tall.
7. Adjust the flame to the desired height with the control knob.
!
WARNING
If burner flame goes out during operation, immediately turn the control knob "OFF" and let the gas
clear a minimum of 5 minutes before attempting to re-light the fire column.
Please refer to the trouble shooting pages for additional support beginning on page 15.
!
WARNING
When using this method to light your fire column use heat resistant gloves and follow the step by step
instructions. Failure to do so could result in severe injury.
12

LIGHTING INSTRUCTIONS