Personalisations; Setting The Temperature; Setting The Spin Speed; Functions - Indesit WIXL 125 Instrucciones Para El Uso

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to a cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cotton 1200 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Function Effect
Delays the start
of the wash by
up to 9 hours.
Delay Timer
Bleaching cycle
designed to
Stain remove the
removal toughest stains.
This option
reduces the
amount of
Easy iron creasing on
fabrics, making
them easier to
iron.
Increases the
efficiency of the
rinse.
Extra Rinse
Comments
Press the button repeatedly until the LED corresponding to the
desired delay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay
can only be decreased if you wish to modify it.
Please remember to pour the bleach into extra compartment 4
(see page 8).
This function is incompatible with the EASY IRON function.
When this function is set, programmes 4, 5, 6, 7 will end with the
laundry left to soak (Anti-crease) and the Rinse cycle phase
LED will flash.
- to conclude the cycle, press the START/RESET button;
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
This function is incompatible with the STAIN REMOVAL function.
Recommended when the appliance has a full load or with large
quantities of detergent.
GB
.
Enabled with
programmes:
All
2, 3, 4, 5,
Rinse cycle.
3, 4, 5, 6, 7,
8, 9, 10,
Rinse cycle.
1, 2, 3, 4, 5,
8, 9, 10, 12,
13, Rinse
cycle.
7