Publicidad
Step 10
Fasten an ADJUSTABLE SHELF MOLDING (F) to an
å
ADJUSTABLE SHELF (E). Tighten three HIDDEN CAMS.
Repeat this for the remaining ADJUSTABLE SHELF (E)
å
and SHELF MOLDING (F).
To prepare for the next step, place the ADJUSTABLE
å
SHELVES (E) exactly as shown below. This is done to
support the BACK attachment in the next step.
NOTE: The ADJUSTABLE SHELF must not be higher than
å
the lower edge of the REAR LEG.
The CAM SCREWS should be
closer to this edge.
Page 14
F
E
Lower edge of REAR LEG
419961
1
2
View shown
without the LEFT
END for clarity.
F
E
E
For support, place packing
foam and magazines here.
F
www.sauder.com/services
Publicidad
