Publicidad
Step 11
NOTE: You will need a tape measure in this step.
å
Unfold the BACK (G) and lay it over the lower edges of the REAR LEGS (H and J) as shown in diagrams #1 and #2. The
å
back should be against the TOP (K).
Diagram 3 and 4. Place the bead of the nail holder down between the BACK (G) and REAR LEGS (J and H) 2" from the
å
corner. Place a NAIL (1N) into the nail slot of the nail holder. Tap the nail through the BACK and into lower edge of the
REAR LEGS. Remove the nail holder from the nail and completely tap the nail in with your hammer. Finish fastening the
BACK to the REAR LEGS with the hammer and nail holder placing nails approximately 5-1/2" apart.
Diagram 5. Fasten the BACK (G) to the BRACE (F). Use three CLIPS (67G) and three BLACK 9/16" LARGE HEAD
å
SCREWS (1S).
NOTE: The CLIPS should wrap around the edges of the BACKS and the teeth of the CLIPS should bite into the BRACES as
å
you tighten the screws.
3.
2"
Bead
Lower edge
2.
J
BLACK 9/16" LARGE HEAD SCREW
www.sauder.com/services
J
F
5.
67G
(3 used)
1S
(3 used in this step)
K
G
H
1.
H
Lower edge
NAIL
(12 used in this step)
419961
Off set edge
nail
holder
Bead
4.
2"
Bead
1N
Nail slot
Page 15
Publicidad
