Above Floor Cleaning - Bissell POWERSWIFT 2598 Serie Guía De Usuario

Power ON & Settings
1
Turn the dial on the foot of the vacuum to desired
setting. If dial is difficult to turn, tilt vacuum back.

Above Floor Cleaning

1
Pull hose up and out of
vacuum base to attach
your desired tool.
NOTE: Before above floor cleaning, remove the TurboBrush® Tool Clip and
TurboBrush Tool from the handle.
Empty Dirt Tank
WARNING
connect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
1
Empty once tank is full.
6
www.BISSELL.com
Bare Floor Setting -
For bare floors or low
pile carpet.
High Carpet Setting -
For high pile and most
shag carpet.
2
For extended reach, lift the
Quick Release Lever on the
back of the vacuum to slide
the Quick Release Handle
out of the base.
To reduce the risk of electrical shock, turn Power Switch OFF and dis-
2
Press the release button at
the top of the Dirt Tank to
remove it from the vacuum.
2
Press down once on the red ON/
OFF pedal located on the lower
back of the vacuum to turn ON.
Press down again to turn OFF.
Remove the hose from
the Hose Wand Base and
connect to the open inlet at
the handle. Connect desired
tool to the end of the wand.
3
Hold Dirt Tank over a trash
container and push the
empty release button located
on the lower backside of the
Dirt Tank. Close lid and return
tank to vacuum base.