USING YOUR STROLLER WITH THE EMBRACE INFANT CAR SEAT
• Only use the Evenflo Embrace infant car seat with this stroller.
Other infant car seats or carriers are not designed to fit the stroller frame and may result in serious injury to your child if
used with this stroller .
• T o assure safety for your baby, please refer to the manufacturer's instructions for the use of your Embrace infant car
seat and keep all instructions available for reference .
• DO NOT lift stroller by using the Embrace infant car seat handle when installed on stroller .
• I f unable to securely attach Embrace infant car seat to this stroller, remove the car seat and contact Evenflo ParentLink
at 1-800-233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
• T o avoid serious injury to the child, when the Embrace infant car seat is in the stroller, make sure the infant car seat is
securely snapped onto the child's tray and secured with car seat stabilizer .
• S ome Embrace infant car seats have a blanket/boot option that must be removed for proper attachment to this stroller
.
1. Fully recline the stroller seat back (page 7).
2. Make sure the child's tray is securely latched (page 5).
Embrace
A
3. The
infant car seat
MUST be in the rear-facing position.
B
Lower the infant car seat down onto the child's tray
A
4. Secure the front of the
Embrace
infant car seat
with the car seat stabilizer
D
channel
, as shown.
5. Pull up on the
Embrace
infant car seat handle to test the lock.
CHECKLIST FOR PROPER INSTALLATION
A
• Make sure the Embrace infant car seat
is in the rear-facing position.
• Make sure the Embrace infant car seat is securely locked onto the child's tray
• Pull up on the Embrace infant car seat to test that it is properly locked into place.
WARNING
and press downward until you hear the lock snap into place.
C
C
. Lift the car seat stabilizer
over the locking
B
and secured with car seat stabilizer
C
.
To remove the Embrace infant car seat, disconnect the car seat stabilizer
D
channel
. Squeeze the release handle
with the other hand.
• Clean minor spills and stains on cloth or plastic surfaces with cold water and mild soap . Air dry .
• Metal and plastic parts can be wiped clean with a soft damp cloth and dried with a soft cloth . DO NOT use abrasive cleaners or
solvents .
• An occasional drop of vegetable oil may reduce wear and tear on moving parts .
USING YOUR STROLLER WITH THE EMBRACE INFANT CAR SEAT
C
from the locking
E
F
with one hand, while lifting up on the carry handle