How To Use Accessory Tray; Low Pressure; High Pressure - Briggs & Stratton ELITE Serie Manual Del Operario

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
Section 4: Operation

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and ProjectPro™
nozzles.
NOTE: The extra hole in the tray is for storing a utility
brush.The extra clip in the tray is for storing a turbo
nozzle.The brush and turbo nozzle are NOT included with
your pressure washer.You can buy these items as optional
accessories.
1. Place nozzle extension through hole on accessory tray,
as shown in Figure 14.
Figure 14 — Typical Accessory Tray
2. Place spray gun through hole on accessory tray on
right side of unit (Figure 14).
3. Insert multi–colored ProjectPro™ nozzles in spaces
provided in accessory tray (Figure 14).
4. Hang high pressure hose on hook attached to handle, as
shown in Figure 14.
www.mymowerparts.com
How to Use ProjectPro™ Nozzle
System
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro™ system nozzles.
The ProjectPro™ nozzles vary the pressure and spray
pattern as shown (Figure 15).
Figure 15 — Nozzle Spray Patterns

Low Pressure

High Pressure

Delicate
40° Yellow 15° Orange
2550 PSI
2.8 GPM
Follow these instructions to change ProjectPro™
nozzles:
1. Engage trigger lock on spray gun.
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER exchange ProjectPro™ nozzles without engaging the
trigger lock on the spray gun.
• DO NOT twist ProjectPro™ nozzles while spraying.
2. Pull back collar on quick–connect and pull current
ProjectPro™ nozzles off. Store ProjectPro™ nozzles in
holder provided on the accessory tray.
12
Black
Use to apply
detergent
Max
General
0° Red
3100 PSI
2800 PSI
2.5 GPM
2.7 GPM