Section 3: Assembly; Add Engine Oil And Fuel - Briggs & Stratton ELITE Serie Manual Del Operario

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

Section 3: Assembly

2. Insert carriage bolts through holes from inside of unit
and attach plastic knob from outside of unit (Figure 2).
Tighten by hand.
Figure 2 — Secure Handle
3. Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit flat against the accessory tray (Figure 3).
Figure 3 — Attach Accessory Tray to Handle
4. Insert "L" bolt through hole just below billboard on left
side of handle (viewing from rear of unit). Hold hook in
place and attach plastic knob from inside of unit
(Figure 4).Tighten by hand.
Figure 4 — Attach "L" Bolt to Handle
Hose Hook
5. Insert multi–colored ProjectPro™ nozzles and other
supplied accessories in spaces provided in accessory
tray. See "How to Use Accessory Tray".
www.mymowerparts.com
Attach Chemical Hose to Pump
Attach chemical hose to chemical injection fitting on pump
(Figure 5).
Figure 5 — Attach Chemical Hose to Chemical Injection
Fitting on Pump

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine operator's manual for oil and fuel fill
information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
8