How To Stop Your Pressure Washer; How To Use Accessory Tray; How To Use Spray Tips - Briggs & Stratton Troy-Bilt PW101-2010 Manual Del Operador

How to Stop Your Pressure Washer

1. Release spray gun trigger and let engine idle for
two minutes.
2. Turn engine off according to instructions given in
engine operator's manual.
3. ALWAYS point gun in a safe direction and press
red button and squeeze spray gun trigger to
release retained high water pressure.
WARNING The high pressure stream of water that
this equipment produces could cut through
skin and its underlying tissues, resulting in
serious injury and possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.

How to Use Accessory Tray

The unit is equipped with an accessory tray with
places to store your spray gun, nozzle extension, high
pressure hose and quick connect spray tips.
1. Place nozzle extension in slots on left side of
accessory tray (viewing from rear of unit) and snap in.
2. Place spray gun through grooves on right side of
accessory tray.
3. Insert multi-colored spray tips in holes provided on
front of accessory tray.
Low Pressure
Use to apply
detergent
Magenta
12
4. Wrap high pressure hose and hang on hook of
accessory tray.

How to Use Spray Tips

The quick–connect on the nozzle extension allows you
to switch between five different quick connect spray
tips. Spray tips can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
spray tips vary the spray pattern as shown.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on
the accessory tray.
WARNING The high pressure stream of water that
• NEVER exchange spray tips without the trigger lock
being engaged on the spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:
•
•
•
•
•
3. Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
White 40° Green 25°
2500 PSI 2600 PSI
2.7 GPM 2.6 GPM
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
For delicate rinse, for gentle cleaning of cars/
trucks, boats, RV's, patio furniture, lawn
equipment, etc., select white 40° spray tip.
For general rinsing, ideal for most all purpose
cleaning such as home siding, brick patios,
wood decks, driveways and sidewalks, garage
floors, etc., select green 25° spray tip.
For maximum rinsing, for stubborn or hard to
reach surface such as second story surfaces,
paint removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red 0° spray tip.
Select cyan jet flush spray tip for quick high
flow clean up and long reach cleaning of
second story siding and windows.
Select magenta jet soap spray tip for general
soap applications or to launch soap to second
story siding and windows.
High Pressure
Cyan Red 0°
3100 PSI
2.4 GPM
www.troybilt.com