Section 3: Assembly - Briggs & Stratton 020258 Instrucciones De Uso

Section 3: Assembly

Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine operaor's manual for oil and fuel fill
information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Remove and discard tape from domed oil filler cap on
top of pump.
2. Uncoil high pressure hose and attach quick connect end
of hose to base of spray gun (Figure 3). Pull down on
collar of quick connect, slide onto spray gun and let go
of collar.Tug on hose to be sure of a tight connection.
Figure 3 — Connect High Pressure Hose to Spray Gun
NOTE: Remove and discard all pump shipping caps before
attaching hoses.
3. Similarly, attach other end of high pressure hose to the
high pressure outlet on pump. Pull down on collar of
quick connect, slide onto pump and let go of collar. Pull
on hose to be sure of a tight connection.
4. Before connecting garden hose to water inlet, inspect
inlet screen (Figure 4). Clean screen if it contains
debris or replace if damaged. DO NOT run pressure
washer if inlet screen is missing or damaged.
5.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6.
There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any flow shut off
device, such as a 'Y' shut-off connector or other convenience-
type water shut-off valve.
• Damage to equipment resulting from failure to follow this
7.
• Always wear safety goggles when using this equipment or in
• Before starting the pressure washer, be sure you are wearing
Connect high
pressure hose here
Checklist Before Starting Engine
Review the unit's assembly to confirm you have performed
all of the following:
1.
2.
3.
4.
5.
6.
7.
8
Figure 4 — Connect Garden Hose to Water Inlet
Run water through garden hose for 30 seconds to
clean out any debris.Turn off water.
Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 4).
CAUTION
instruction will void warranty.
Turn ON water, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
WARNING
High pressure spray can cause paint chips or
other particles to become airborne.
vicinity of where equipment is in use.
adequate safety goggles.
Make sure handle is secure.
Check for properly tightened hose connections.
Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
Check that oil has been added to proper level in
engine crankcase.
Add proper fuel to fuel tank.
Provide a proper water supply (not to exceed 100°F).
Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using pressure washer.
Inspect inlet screen.
DO NOT use if
damaged or missing;
clean if dirty.