KNOVA KN RXW-10Q Manual De Instrucciones página 10

ASSEMBLE AND ADJUSTMENTS
4. Place a machinist's square flat on the table and slides
it against the riving knife as shown in Figure 16:
Fig. 16 (checking vertical alignment)
--- If the square lies flat against the riving knife,
the riving knife is correctly adjusted.
--- If there is a gap between the square and
the riving knife, go to Step 6.
5. Loosen the riving knife center bolt and remove
the riving knife.
6. Use the set screws shown in Figure 17 to adjust
the riving knife bracket and re-install the riving knife.
Fig.17 (set screw for adjusting riving knife)
7. Repeat step 3-7 until the riving knife is centered
on the blade and aligned at 90º to the table.
8. Position the riving knife about 3mm or 1/8" away
from the nearest carbide tooth on the main blade.
9. Lock the riving knife on the safety and appropriate
position.
ASSEMMBLE THE BLADE GUARD:
1. Before installation the blade guard (N), please confirmed
Fig.18 the handle (M) keep on open as Fig.19.
O
2. Pull up the guards as Fig.18.
3. Insert the guards on the position O & P
of spreader as Fig.18.
Fig. 19
9
M
N
P
Fig. 18
M