KNOVA KN RXW-10Q Manual De Instrucciones página 11

ASSEMBLE AND ADJUSTMENTS
4. Put down the guards(N) as Fig.20 and lock
the handle(M), then fix the handle(M) as Fig.21.
Fig. 20
Fig. 21
Check the 45º setting. Tilt the blade with the bevel hand
wheel as far as it will go to the left. Place the square against
the blade (be sure the square is not against one of the saw
teeth). If the blade is not at 45º, unscrew the 45º stop screw,
turn the hand wheel until the blade is correct, and tighten the
screw. Recheck and repeat it necessary.
Check that the scale indicator is at 45º.
If not, loosen the scale indicator with a screwdriver, adjust it
within the slot, and retighten the screw.
Fig. 22
M
N
M
SWITCH INSTALLATION:
Install the switch on the location as Fig.23 with the hex. Screw
M8xp1.25x12. Lock the screw on the extension wing .
Fig. 23
POWER SWITCH PADLOCK
To avoid accidental starting by young children or others not
qualified to use the tool, the use of a padlock is required.
To lock out an power switch:
1. Open the padlock. See fig. a
2. Insert through hole in the start button. See fig. b
3. Close the padlock.
4. Place the key in a safe place out of the reach of children.
(a)
10
Fig. 24
(b)