Putting Into Service; Operation; Displays; Technical Data - ADE Serena Instrucciones De Operación

Thank you for purchasing this high-quality ADE product. You have acquired a set of
scales that meet the highest technical standards and are of proven quality.
Please read these operating instructions carefully before using the product for the first
time and keep them in a safe place where you can find them whenever you need the
information contained in the instructions.
1.

Putting into Service

Safety information:
Ensure that no objects fall onto the scales; otherwise, the scales
may be damaged.
Use only a damp cloth to clean the scales. Never use solvents or
abrasive cleaning agents. Do not submerge. You must clean all the
plastic parts of the scales immediately after they come into contact
with grease, spices, vinegar or any other strongly spiced or
coloured foods. Avoid any contact with citric acid.

2. Operation

Switching on the scales:
Place the scales on an even and solid surface; light strength at that position must be at
least 100 lux - wait until the solar icon "READY" begins to flash.
Press the ON/TARE/OFF button on the right of the display to switch on the scales. The
display first shows all icons, and once it has stabilised, the display "0 g" or "0: 0.0 lb:
oz.", "0.0 fl.oz" or "0 ml" will be shown depending on setting. The scales are now ready
to use.
Note: If a weight is shown on the display after switching on, simply press the button
ON/TARE/OFF to set the scales to "0".
Switching between units of weight:
Pressing the UNIT button on the left of the display allows you to switch between country-
specific units of weight (g = grammes / fl.oz = fluid ounces / lb oz = pounds ounces / ml
= millilitres). Please ensure that the scales are set to the appropriate units of weight for
you.
2
Tare weight function:
Pressing the ON/TARE button will set the scales to "0 g". Switch on the scales and place
e.g. a bowl on the weighing platform, touch the ON/TARE/OFF button and reset the
scales to "0 g" (the tare icon will appear on the left of the display if the tare weight is above
600 g: "TARE". You can repeat this procedure as often as you like until the total capacity
of the scales (5 kg) has been reached. After you remove the item(s) from the scales, the
total weight is displayed as a minus value (display: Minus icon –).
Automatic/manual switch-off of the scales:
The scales switch off automatically if no weight change is registered for about 180
seconds. Pressing the ON/TARE/OFF button for about 2 seconds will switch off the scales
manually after use.

3. Displays

"READY" = Sufficient power – scales are ready to use.
"EEEE" = Overload – max. load capacity of 5 kg has been surpassed.
Immediately remove the load from the scales; otherwise, the
load cell could be damaged.

4. Technical Data

Load capacity x graduation: Max. 5 kg x 1 g
Dimensions: 150 mm x 250 mm x 26.5 mm
Subject to technical changes due to further development of the product.

5. Warranty

ADE guarantees to rectify any material or manufacturing defects by way of repair or
replacement free of charge for a period of three years from the purchase date. At the time
of purchase, please get the retailer to fill in and stamp the guarantee card. In case of a
warranty claim, please return the scales to your retailer with the guarantee card and
stating the reasons for the claim.
CE conformity
This device is interference-suppressed in accordance with the
applicable EU Directive 2004/108/EC
3