Datamars Unigizer 15 J Guía De Instalación Y Uso página 17

If... This means that...
The first red The earth monitor voltage is too high.
Indicator light is Use the earth monitoring feature to
illuminated monitor the earth. See
permanently... on page 9.
The battery symbol The battery voltage is bad. Check the
on the LCD is battery voltage immediately, using the
flashing... battery test setting. See
battery voltage
The right arrow on During the first 10 minutes of operation,
the LCD is the energizer's remote control feature
flashing... can be activated. During this period, the
large arrow on the LCD display flashes
to indicate this. This occurs each time
the energizer is switched on when the
energizer's remote control feature has
not been activated This is part of normal
operation.
The energizer is not The energizer has been switched off by a
pulsing and the last remote control handset. If you think your
green Indicator light energizer might be being controlled by a
is flashing... neighbour's remote control handset and
you own a remote control handset
yourself, change your energizer's
address setting (see the remote control
handset's user manual). If you do not
have a remote control handset, take the
energizer to an authorised service centre
to have the remote control feature
disabled.
Servicing
This energizer uses Double Insulation, where two systems of
insulation are provided instead of grounding. No equipment
grounding means is provided in the supply cord of a double-
insulated energizer, nor should a means for equipment
grounding be added to the energizer. Servicing a double-
insulated energizer requires extreme care and knowledge of
the system and should only be done by qualified service
personnel. Replacement parts for a double-insulated
energizer must be identical to the parts they replace. A
double-insulated energizer is marked with the words
DOUBLE INSULATION or DOUBLE INSULATED and/or the
symbol below.
Earth monitoring
Testing the
on page 9.
17