Optional Accessories; Protecting The Environment - DeWalt DW682 Manual De Instrucciones

INSIDE SURFACES ALIGNED
1. Arrange the workpieces as they are to be
assembled.
2. Mark the biscuit centres on the inside of
the joint.
3. Set the fence angle to 45°.
4. Adjust the fence to locate the biscuit toward the
inside of the joint where the workpiece is thicker.
Select the appropriate biscuit size.
5. Clamp the workpiece and align the tool as
shown (fig. 19d).
6. Cut the biscuit slots as described above.
T-Joints (fi g. 20a–20e)
This type of joints is commonly used to attach
shelves to side panels (fig. 20a).
1. Place the workpieces on a flat surface as they
are to be assembled (as an upside down T).
2. Mark the biscuit centres on the shelf piece.
3. Lightly mark the top of the shelf on the side
panel (fig. 20b).
4. Clamp the fence on top of the side panel,
aligning the end of the shelf with the line
(fig. 20c).
5. Select the appropriate biscuit size.
6. Set the fence to 0°.
7. Align the tool with the biscuit marks using the
markings on the tool base.
8. Make a vertical (fig. 20d) and a horizontal
(fig. 20e) cut at each of the biscuit locations.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products and
packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
EN G LI SH
WALT, have
E
WALT product
E
35