Care And Maintenance - Medisana CardioDock 2 Instrucciones

6 Miscellaneous

6.2 Care and maintenance

Your CardioDock blood pressure module is a high-precision instru-
ment. Handle with care to avoid damaging the electronics and prevent
defects.
Observe the following instructions:
Never use strong detergents or hard brushes.
•
Clean the unit using a soft cloth lightly moistened with a mild soapy
•
solution. Do not allow any water to get into the unit. Do not use the
unit again until it is completely dry.
Do not expose the unit to direct sunlight, and protect it from dust and
•
moisture.
• Only inflate the cuff when it is in position around the upper arm.
• Keep the cuff clean. If it gets dirty, separate it from the device and
clean it with mild soapy water. Rinse it thoroughly with cold water and
let it dry in the air. Do not put the cuff in a dryer and do not iron it.
• Even if you do not use the device for a long time, charge it fully once a
month.
• Put the module back in its carrying case after each use.
• Servicing and calibration
The unit has been calibrated by the manufacturer for a period of two
years' use. In the case of commercial use, the unit must be serviced
and recalibrated at least once every two years. This calibration will be
charged for and can be carried out by an appropriate authority or an
authorised service centre - in accordance with the regulations for
users of medical equipment.
6.3 Guidelines / Standards
This blood pressure monitor meets the requirements of the EU stan-
dard 93/42/EEC for non-invasive blood pressure monitors. It is certified
in accordance with EC Guidelines and carries the CE symbol (confor-
mity symbol) „CE 0483".
13
GB
G
G
G
G
G
G
G
G
G
G
G
G