Flex FX6151 Manual Del Operador página 9

WARNING
performing any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
TO ATTACH/DETACH BATTERY PACK (FIG. 2)
NOTICE: The batteries are not fully charged
on delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool until it clicks into place.
NOTICE: When placing the battery pack onto
the tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool
and that the latches snap into place properly.
Improper attachment of the battery pack can
cause damage to internal components.
To detach the battery pack:
MOUNTING/CHANGING THE MIXER PADDLE
a. Loosen the chuck to open the chuck jaws
(Fig. 3).
Fig. 3
a
Chuck jaws
Detach the battery pack
from the tool before
ASSEMBLY
Fig. 2
Depress the battery-release button located
on the front of the battery pack to release the
battery pack. Pull the battery pack out and
remove it from the tool.
CAUTION
contacts. Loose metal parts may short-circuit
the contacts; explosion and fire hazard!
b. Insert the paddle between the chuck jaws
and ensure that it is in the center of the chuck
jaws (Fig. 4).
c. Fully tighten the mixer paddle with the key.
Fig. 4
-9-
When the device is not in
use, protect the battery
c
b