Getting Started; Filling The Reservoir - Waterpik WP-400 Guía De Iniciación Rápida

6 6

GETTING STARTED

Fill
Insert
Eject
Pressure
Setting
Plug the cord into any standard electrical outlet. Make sure you push the switch into the OFF (0) position before charging. The unit will
not charge if the switch is in the ON (I) position. See "Cleaning and Troubleshooting Your Waterpik® Water Flosser" for guidance on how
to look after your battery. The Waterpik® Water Flosser will stay charged for up to 2 weeks depending on use.

Filling the Reservoir

Remove the charger from the unit prior to filling reservoir and product use. Lift flip top on reservoir and fill the reservoir with
lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. Press firmly until the tip clicks into place. To remove the tip
from the handle, press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by sliding pressure control on the handle. Start with the lowest setting and
increase to your liking.