General Safety Practices - Skymsen LC2 Manual De Instrucciones

These substances attack the stainless steel due to the CHLORINE on its composition,
causing corrosion spots (pitting).
Even detergents used in domestic cleaning must not remain in contact with the stainless
steel longer than the necessary, being mandatory to remove it with plain water and then
dry the surface completely.
Use of abrasives:
Sponges or steel wool and carbon steel brushes, besides scratching the surface
and compromising the stainless steel protection, leave particles that rust and react
contaminating the stainless steel. That is why such products must not be used for cleaning
and sanitization. Scrapings made with sharp instruments or similar must also be avoided.
Main substances that cause stainless steel corrosion:
Dust, grease, acid solutions such as vinegar, fruit juices, etc., saltern solutions (brine),
blood, detergents (except for the neutral ones), common steel particles, residue of sponges
or common steel wool, and also other abrasives.

4. General Safety Practices

IMPORTANT
If any recommendation is not applicable to your equipment, please ignore it.
The following safety instructions are addressed to both the operator of the machine as
well as the person in charge of maintenance.
The machine has to be delivered to the operator in perfect conditions of use by the
Distributor to the user.
The user shall operate the machine only after being well acquainted with the safety
procedures described in the present manual. READ THIS MANUAL WITH ATTENTION.
12