Cutting Tips; Advancing Line; Advancing The Line Manually; Line Cut-Off Blade - Ryobi RY40204 Manual Del Operador

Ocultar thumbs Ver también para RY40204:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CUTTING TIPS

See Figures 10 - 11.
 Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
 The string trimmer cuts when passing the unit from right
to left. This will avoid throwing debris at the operator.
Avoid cutting in the dangerous area shown in figure 10.
 Use the tip of the line to do the cutting; do not force string
head into uncut grass.
 Wire and picket fences cause extra line wear, even
breakage. Stone and brick walls, curbs, and wood may
wear line rapidly.
 Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the line.

ADVANCING LINE

NOTE: The trimmer is equipped with an auto-feed head.
Bumping the head to try to advance the line will damage
the trimmer and void the warranty.
 With the trimmer running, release the switch trigger.
 Wait two seconds, and press the switch trigger.
NOTE: The line will extend approximately 1/4 in. with each
stop and start of the switch trigger until the line reaches
the length of the cut-off blade.
 Resume trimming.
All manuals and user guides at all-guides.com
OPERATION

ADVANCING THE LINE MANUALLY

See Figure 12.
 Remove the battery pack.
 Push the black button located on the string head while

LINE CUT-OFF BLADE

See Figures 13.
This trimmer is equipped with a line cut-off blade on the grass
deflector. For best cutting, advance line until it is trimmed to
length by the line cut-off blade. Advance line whenever you
hear the engine running faster than normal, or when trimming
efficiency diminishes. This will maintain best performance
and keep line long enough to advance properly.
This trimmer is currently set at the 10 in. cutting swath. To
adjust to a cutting swath of 12 in.:
 Remove the battery pack.
 Loosen the blade screw then rotate the line cut-off
 Tighten the blade screw.
9 — English
pulling on line to manually advance the line.
blade 180°.

Publicidad

Tabla de contenido
loading

Tabla de contenido