Replacing The Cavity Light - Whirlpool WMT55511KS Manual Del Propietário

Cavity Light is located at the top front of the microwave oven,
under the cover and is replaceable. Before replacing lamp, make
sure lamp is cool.
To replace the cavity light refer the following steps:
1. Use a Phillips head screwdriver to remove the 4 wood screws
securing the trim kit frame to the cabinet.
A. Trim kit frame
B. Mounting hole guide
C. #7-16x15/16" flat head wood screw (4)
D. Cutout ceiling
WARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other injury.
2. Using 2 people, slide the microwave oven out of the cabinet.
Unplug the microwave oven and place on a stable surface with
the microwave door and frame sitting slightly beyond the edge
of the surface.
B
A
A. Cabinet
B. Microwave Oven
3. Remove the 3 short screws to release the leftside cooling duct,
see below pictorial. Set screws and cooling duct aside.
A. Leftside Cooling Duct
B. Short Screws (3)
C. Screw holes (3)
12
MICROWAVE OVEN CARE

Replacing The Cavity Light

B
A
C
4. Remove the 4 screws which fasten the trim kit frame to the
microwave oven, and set the 4 screws aside.
A. Trim Kit Frame
B. #7-18x7/16" round head sheet metal screw (4)
C. Screw holes (4)
5. Pull the Trim Kit Frame away from the front of the microwave
to release it. Note the 'TOP' and 'up arrow' molded into the
frame, the 4 locating pins and the locating slots, set frame
aside.
B
C
A. Trim Kit Frame
B. Locating pin (4)
C. Locating slot (4)
6. Remove the light cover screw from the top front of the
microwave oven.
7. Remove the light cover.
8. Pull out the halogen light from the light holder.
9. Replace with a new halogen light.
A
B
C
A
Screw
Light cover
Top front of the
microwave oven