Connect To The Power Supply - KENMORE ELITE 796.4051 Manual De Uso Y Cuidado

I CONNECTING THE DRAIN HOSE
•The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
flooding and property damage.
• Do not install the end of the drain hose higher than 96 in.
(243.8 cm) above the bottom of the washer.
•The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
NOTE:
A drain hose extension kit is
available if the drain hose is not
long enough. Do not extend
drain hose more than 6 feet, as
this will cause poor draining
resulting in poor wash and spin
performance.
f _Drain Hose Extension 1
(_ P/N 5215ER2002K
Option 1" Standpipe
Elbow Bracket
Tie
Strap
Install the end of the drain hose into the elbow bracket. Do
not extend the drain hose more than 4 inches past the end
of the elbow bracket. Use tie strap to secure the drain hose
in place.
NOTE:
•Total height of the hose end should not exceed 96 in.
(243.8 cm) from the bottom of the washer.
•The drain hose should be inserted no more than 8-12
inches into the standpipe.
• Extending the drain hose more than 4 inches past the end
of the elbow bracket can cause mold or microorganisms to
spread to the inside of the washer.
Option 2: Laundry Tub
Elbow Bracket
Tie Strap
Drain Hose
The elbow bracket should be installed near the end of the
drain hose. Hang the end of the drain hose over the side of
the laundry tub. Use tie strap to secure the drain hose in
place.
Option 3: Floor Drain
f-
Drain Hose
Floor Drain _.r__._...... _
Insert the end of the drain hose into the floor drain.
If possible, secure the hose to prevent it from moving or
coming out of the drain.
I CONNECT TO THE POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz grounded
3-prong outlet.
Plug in the washer.
10