Technical Data; Inserting/Replacing The Batteries - Bosch Truvo Manual Original

OBJ_BUCH-2841-002.book Page 18 Thursday, August 4, 2016 6:22 PM
18 | English

Technical Data

Digital Detector
Article number
Maximum scanning depth*:
– Ferrous metals
– Non-ferrous metals (copper pipe)
– Copper conductors (live)**
Calibration
Automatic switch-off after approx.
Operating temperature
Storage temperature
Relative humidity
Batteries
Operating lifetime (alkali-manganese batteries)
approx.
Weight according to EPTA-Procedure 01:2014
* depending on material and size of the objects as well as material and condition of the
base material (walls, ceilings, floors)
** less scanning depth for wires/conductors that are not "live"
 In terms of accuracy and scanning depth, the measurement result can be infe-
rior in case of unfavourable surface quality of the base material.
The measuring tool can be clearly identified with the serial number 6 on the type plate.
Assembly

Inserting/Replacing the Batteries

Alkali-manganese batteries are recommended for the operation of the
measuring tool.
To open the battery lid 5, press on the latch 4 and fold the battery lid up.
Insert the batteries. When inserting, pay attention to the correct polarity
according to the representation on the inside of the battery compartment.
 Remove the batteries from the measuring tool when not using it
for extended periods. When storing for extended periods, the batter-
ies can corrode and self-discharge.
1 609 92A 3FC | (4.8.16)
Truvo
3 603 F68 2..
70 mm
60 mm
50 mm
automatic
10 min
0 °C...+40 °C
–20 °C...+70 °C
30 ... 80 %
3 x 1.5 V LR3 (AAA)
5 h
0.15 kg
Bosch Power Tools