ESAB PEI Instrucciones De Uso página 58

GB
3. Connect the welding head to the terminal 1 on X2.
Use the appropriate hole and the rubber gland for the cable output.
N.B. Do not remove any jumpers.
*1 Welding head
*2 Welding power source
4. Put the rear panel back into place and screw in the screws (see on page 57).
5. Connect the power source and the controller by means of the control cable to the
socket X1 placed on the rear panel of the unit.
6. By means of a screwdriver, select an appropriate start mode (DIRECT/
SCRATCH), see on page 56. External mode is not supported.
7. Adjust the approximate value of the burn--back time.
Make further adjustments after welding tests. See on page 56.
8. Connect the current cables to the welding head and the workpiece.
fgc6i1ea
- - 58 - -