2 Using The Pet Hair Turbine Tool; 2 Stairways And Landings; 2 Agitator Motor Overload Protection; 2 Thermal Overload Protection - LG LuV350P Serie Manual Del Propietário

12
OPERATION
Using the Pet Hair Turbine Tool
The Pet Hair Turbine Tool features a turbine-powered agitator to provide
extra cleaning power on carpets and fabrics. It is great for cleaning stairs,
cushions and vehicle upholstery.
When using the pet hair turbine tool, check the brush area frequently for
buildup of hair, fibers, lint and other debris.
Excessive buildup can reduce performance and could damage the pet hair
turbine tool. See the Care and Cleaning section for cleaning instructions.
Stairways and Landings
Use the dusting brush or pet hair turbine tool on stairs and landings. Make
sure that the vacuum cleaner is placed so that it cannot tip or fall.
Agitator Motor Overload Protection
The agitator has a built-in protection against motor damage
should the agitator jam. If the agitator slows down or stops, the
agitator overload protector shuts off the agitator and suction
motor.
To correct problem: Turn off and unplug the vacuum cleaner. Remove
the obstruction and turn on the vacuum cleaner by pressing the Power
button, and then press the Floor/Carpet button.
Thermal Overload Protection
This vacuum cleaner has a thermal overload protector that automatically
activates to protect the vacuum cleaner from overheating. If a clog
disturbs the normal flow of air to the motor, the thermal protector turns
the motor off automatically to allow the motor to cool in order to prevent
possible damage to the vacuum cleaner.
To correct the problem: Turn the vacuum cleaner off and unplug the
power cord. Check for and remove clogs, if necessary. Also check and
clean any dirty filters.
Wait approximately 30 minutes and then plug the vacuum cleaner in
and turn it back on to see if the motor protector has reset. The thermal
protector system will not reset until the vacuum cleaner has completely
cooled down.