Routine Maintenance; Sawdust Chamber; Drums; Wheels - Bona Belt UX Manual De Funcionamiento Y Mantenimiento

Machine Adjustment Procedures (Cont.)
Wheel adjustment (cont.)
In order to adjust it proceedas follows:
1. 2.
With the tool provided with Turn the screw (B) .
the machine, loosen the nut.

Routine Maintenance

To keep the machine in good working condition the following items must be checked and serviced regularly.

Sawdust chamber

Vacuum the sawdust chamber regularly.
Roulette murale

Drums

Check the outer surface of the drum regularly. Remove any dirt.

Wheels

Roulette murale
Remove dirt from the machine unit and wheels regularly.
Dirt may cause uneven sanding.

Dust bag

Roulette murale
Remove the bag and shake it well to remove sawdust.
Turn the bag inside out and wash it in the machine in cold water to prevent blockage of the pores and a decrease in dust
collection ability. We strongly recommended the Bona DCS as an alternative to the fabric bag.

Belt tension

Réglage des roues (suite)
Check belt tension regularly. If the belt is excessively worn it must be replaced.
(For adjustment procedures see page 13 of this manual)
24
Bona Belt UX Manual
3.
4.
Check that the operates Lock the nut.
parallel to the surface to be
sanded.
Routine Maintenance (Cont.)
Excessive belt tension may cause the premature failure of the ball bearings. The drum belt must
have a 10.5 mm stretch with a center load of 30±3 N.

Drum pulleys and motor pulleys

Réglage des roues (suite)
Regularly check that the groove (A) of the pulley has not sunk, otherwise the belt (B) will operate on the
bottom (C) of the pulley itself.
Pulleys with sunken grooves cause the belts to slip and the correct power will not be transferred
to the drum/suction pipe.
This situation can easily occur if the machine loses power during operation. They should therefore
be replaced.

Bearings

Réglage des roues (suite)
Check bearings regularly for wear or damage according to the following timescales:
Wheels: After the first 2500 hours
Fan Shaft: After the first 2500 hours
Sanding Drum: After the first 5000 hours
Motor Shaft: After the first 5000 hours
EN
Bona Belt UX Manual
25