Tronic TPB 5000 A1 Instrucciones De Uso página 87

Connect the supplied charging cable 7 or the origi-
♦
nal charging cable of the device you want to charge
to one of the three USB outputs (4, 5 or 6).
♦ Then connect the device you want to charge to the
power bank 1. The charging process begins auto-
matically.
♦ If charging does not start automatically, press the
ON/OFF button 2 once briefly to start the charging
process.
NOTE
► The integrated Smart Fast Charge technology
enables reduced charging times for compatible de-
vices. Compatible connected devices automatically
receive a signal to draw the maximum available
charging current.
During the charging process, the charge level LEDs 3
♦
show the current charge level of the power bank (see
table in the section Checking the charge level).
♦ To stop charging, disconnect the charging cable from
the mobile device and the power bank. The charging
status LEDs 3 go out after about 35 seconds.
Optionally, you can press the ON/OFF button 2
♦
twice in quick succession to turn off the power bank
and the battery level LEDs 3.
│ GB │ MT
■ 84
TPB 5000 A1