How To Maintain - Eureka 900 Serie Guia Del Propietario

1.
3.
8
2.
4.
ENGLISH
!
Caution: Unplug from electrical outlet before servicing.
MAINTENANCE
Note: Never operate the cleaner without the dust bag and filters
installed.
The paper bag and filters play a very important role in the efficiency of the
vacuum cleaner. The purpose of the paper bag is to trap dirt and at the
same time the paper must be porous enough to allow air to pass through.
If the paper bag or filters become clogged, no air can pass through the
cleaner and no cleaning takes place regardless of how powerful the unit.
To keep the cleaner operating at maximum efficiency, change the dust
bag frequently and clean the filters as necessary.
Some fine particles can restrict airflow very quickly and will decrease
performance even before the bag appears to be full. When vacuuming
carpet fresheners or cleaners, plaster dust, or similar fine substances,
clean the bag and filters more often.
BAG CHANGE INDICATOR
The bag change indicator bar fills as the airflow through the bag de-
creases. Certain types of fine particles like powder, plaster dust, or carpet
fibers can restrict airflow very quickly and will decrease performance
even before the bag appears to be full. When the warning appears,
change the disposable dust bag to restore maximum performance. If a
clean dust bag does not restore maximum performance, clean the filters
and check the hose and wands for obstructions.
NOTE: Bag indicator is functional only when cleaner is running.
REPLACING THE DUSTBAG - STYLE CN-4
•
If you forget to attach the dustbag or attach it in the wrong manner,
the bag cover may not close completely.
•
After removing the hose, open the bag cover by pushing the bag
cover latch.
1 Rotate the support of the bag to the vertical position.
•
Remove the dustbag and insert a new one.
•
Close the cover by pressing down until secure.
REPLACING THE FILTERS
Filters should be cleaned or replaced when they become visibly soiled
or suction power is reduced. Always operate the cleaner with the filters
installed to avoid motor damage. The dust bag must be changed and
the filters cleaned or replaced if the window of the Clean Filter Indicator
changes into red when the cleaner is operating at maximum power and
the nozzle is raised from the floor.
Cleaning the motor filter (located behind dust bag inside cleaner)
PN 407 14 37-55.
1
Pull dustbag upward and remove the motor protection filter.
4 Rinse the filter under tap water and dry it completely.
1 Put the filter back into the cleaner and close the cover.
Cleaning the exhaust filter PN 407 14 37-56
2,3
Open the filter grill and remove the exhaust filter.
4 Rinse the filter under tap water and dry it completely.
2,3 Put the filter back into the cleaner and close the filter grill.