Assembly; Assembling The Angle Gear And Sweeper Rollers - Husqvarna SR600 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

K
1. Slide the plastic sleeve (wear protection) (A) onto the
tube (B).
2. Fit the gearbox (C) on the tube (B). Tighten clamp screw
(D) at the gearbox. Tighten the two locking screws (E)
on the gearbox.
3. Press one of the roller shafts (F) onto one of the two
output drive shafts from the gearbox. If necessary rotate
the roller shaft so that the hole for the pin lines up with
the corresponding hole in the drive shaft.
4. Secure the roller shaft on the drive shaft using a pin (G)
and hairpin spring (H).

ASSEMBLY

G
C
F
E
H
I
E
D
A
5. Slide one of the sweeper rollers (I) onto the fitted shaft.
The end with the extended rubber blades must be fitted
closest to the gearbox. Slide the sweeper roller on until it
touches the pin.
6. Secure the roller to the shaft using a split pin (K) (see
diagram). The split pin must be flush with the outer end
of the roller, so you may need to push on the end plate
slightly to fit it. Bend back the legs of the split pin as
shown, to ensure that the sweeper roller is held in place.
7. Repeat steps 1–7 to fit the shaft and roller on the other
side.
CAUTION! The rollers are identical, but they must both
be fitted with the extended rubber blades nearest the
gearbox.
B
7
English –

Publicidad

Tabla de contenido
loading

Tabla de contenido