Assembly; To Assemble The Loop Handle; To Disassemble The Cutting Attachment Guard And Trimmer Head; To Assemble The Cutting Attachment Guard And Trimmer Head - Husqvarna 426LST Manual Del Usuario

• Only use cutting attachments with the guards we
recommend. Refer to
Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.

To assemble the loop handle

1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the cutting attachment guard and
trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head (See,
2. Put the cutting attachment guard onto the fitting on
the shaft.
1189 - 001 - 08.07.2019
Accessories on page 19 .
Accessories on page 19 ).

Assembly

3. Secure with the bolt(L).
L
4. Install the drive disc (B) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (C) in the hole to lock the shaft.
7. Turn the trimmer head (H) in the opposite direction
from which the trimmer head rotates.
To disassemble the cutting attachment guard
and trimmer head
1. Turn the trimmer head (H) in the direction from which
the trimmer head rotates.
2. Pull the locking pin (C) out from the hole to unlock
the shaft.
3. Remove the drive disc (B) on the output shaft.
B
C
A
9