Assembly - Husqvarna 329L Manual Del Usuario

Introduction
WARNING Before you assemble the
product, you must read and understand the
safety chapter.
WARNING Remove the spark plug cable
from the spark plug before you assemble the
product.
To install the loop handle
1. Put the loop handle between the arrows on the shaft.
2. Tighten the bolt to attach the loop handle to the
shaft.
To assemble the cutting attachment
To assemble the cutting attachment guard
• Put the cutting attachment guard (A) onto the fitting
on the shaft and attach it with the bolt (L).
L
A
8

Assembly

To attach the trimmer head
1. Make sure that the cutting attachment guard (A) is
attached to the product. Refer to
cutting attachment guard on page 8 .
2. Make sure that the drive disc (C) is attached to the
output shaft (D).
3. Put a screwdriver (B) in the hole to lock the shaft.
4. Put the trimmer head (E) on the output shaft.
5. Turn the trimmer head (E) counterclockwise to
tighten it to the output shaft.
6. Remove the screwdriver.
To assemble the
D
C
B
A
E
1293 - 001 - 18.09.2019