Automatic Reset; Service + Support - SNOWJOE SJ626E Manual Del Operador

Fig. 27
Screw
NOTE: Heavy wet snow puts a load on belts, thus
requiring more frequent belt replacement.
4. To install the new belt, lift the belt tension pulley and roll
the new belt onto the small pulley at an angle. Then roll
the belt onto the top of big pulley by rotating the big pulley
counterclockwise as the belt grips the top of the big pulley
(Fig. 28).
Fig. 28
Belt tension
pulley
Belt
Big pulley
5. Replace the left panel of the snow blower with all screws.
Replacing the Skid Shoes
The skid shoes are located at the bottom of the side panels.
Unfasten the two screws on the side panel to remove the worn
skid shoes (Fig. 29). Install the replacement by fastening it to
the side panel with the same two screws.
Fig. 29
Skid shoe

Automatic Reset

The snow thrower has built-in automatic reset functions. In the
event of a major obstruction that halts auger movement,
simply unplug your unit, clear the auger obstruction, wait
60 seconds, and then resume use of your machine.
Washer
Storage
1. Allow the engine to cool completely before cleaning,
storing, or transporting the snow thrower.
Be sure to secure the unit while transporting.
2. Disconnect the extension cord from the snow thrower.
Inspect the extension cord closely for signs of wear or
damage. Replace it if it is worn or damaged.
3. Inspect the snow thrower carefully for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. For repairing or replacing parts,
contact your authorized Snow Joe
or the Snow Joe
1-866-SNOWJOE (1-866-766-9563).
4. Store the unit, along with the disconnected extension
cord, in a locked, dry place out of the reach of children to
prevent unauthorized use or damage. Cover loosely with a
tarp or with the Snow Joe
thrower cover (Model SJCVR-24) for added protection.
Visit snowjoe.com to purchase the cover online.

Service + Support

If your Snow Joe
service or maintenance, please call 1-866-SNOWJOE
Small pulley
(1-866-766-9563) for assistance.
Model + Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
on the main cover of the unit to the left of the discharge chute.
Copy these numbers into the space provided below.
Record the following numbers from the housing or handle of your
new product:
S J
Screws
14
+ Sun Joe customer service center at
® ®
universal 24-inch electric snow
®
SJ626E electric snow thrower requires
®
Model #:
6 2 6 E
Serial #:
+ Sun Joe dealer
® ®