Tool Storage - Craftsman CMXEVBCV1260L Manual De Instructiones

LUBRICATION
39. No lubrication is necessary as the motor is equipped with
lifetime lubricated bearings.

TOOL STORAGE

40. Set tank cover onto the tank. Position back of tank facing
you.
41. Take tool holder 18 and slide over notches located on
rear of tank. Fig. 17.
HOSE STRAP
10
42. Wrap hose strap 19 .Fig. 18 around hose 12 aligning
raised areas on back of strap 19 into a groove on hose
12 . Fig. 19.
43. Insert button #1 into button hole #1 Fig. 19 (this may be
difficult at first), continue to wrap hose strap 19 around
hose 12 Fig. 20. Insert button #2 into button hole #2
Fig. 21.
Button hole #2
Fig. 18
Button hole #2
Fig. 19
Fig. 17
Button hole #1
Raised area
(fits in groove of hose to
prevent it from slipping)
Button hole #1
Button #1
Button #2
Fig. 20
Fig. 21
44. Place vacuum tools in tool holder 18 . Fig. 22. The
vacuum should be stored indoors.
Fig. 22
Register Online
Thank you for your purchase. Register your product now for:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.craftsman.com/registration
ENGLISH
8