Alerts/Notifications
18
Description
Display message
Cleaning of milk
Press the Cleaning button for
system
3 seconds to start cleaning
Milk system clean-
Cleaning in progress 28:15:
ing mode
Milk too warm for
Ready
best foam
Milk too warm for best foam
(43–54 °F)
Replace milk with
Ready
cold milk
Replace milk with cold milk
(above 54 °F
[12 °C])
Open lever
Open the lever
Preparation time
Ready
too long
Preparation too long
Preparation time
Ready
too short
Preparation too short
Heating up boiler
Heating up
Energy Saving
Energy Saving mode:
mode
Press any button
Maximum Energy
Saving mode
Brewing unit end
Brewing unit end of life!
of life
CCI not connected
CCI NOT CONNECTED
LED status
Please wait
Alternating
Alternating
Ready
Ready
Alternating
Ready
Remarks
Start the cleaning procedure as
described on ► page 14 .
To quit the menu, press any prod-
uct button.
Display shows remaining cleaning
time.
Normal operation.
Milk products are still available but the
quality might be reduced.
Replace milk with cold milk at 40 °F.
Milk products are locked.
Replace milk with cold milk at 40 °F
[5 °C].
Lift up the lever to eject the used
capsule.
Open the lever and try to insert a
new capsule.
Make sure main water supply is
turned on.
If the message persists, call your
Nespresso representative.
Open the lever and try to insert a
new capsule. The message appears
if no capsule is inserted.
If the message persists, call your
Nespresso representative.
Slow flashing during heating.
If the message remains for more
than 30 minutes, call your Nespres-
so representative.
Boiler temperature reduced.
The machine will be ready within 1 min-
ute after pressing any product button.
To reactivate the machine, press
the Energy Saving button.
For more info ►see page 10 .
Immediately call your Nespresso
representative.
All products blocked. Rinsing and clean-
ing still possible.
Check that the CCI connection
is properly installed. If the alert
persists, call your Nespresso repre-
sentative.