JANE nurse ELEPHANT Instrucciones página 8

ELEPHANT
INSTRUCTIONS FOR ASSEMBLY AND USE
1
ASSEMBLING THE WHEELS
Insert metal pins A into the rear whels R1 (Fig. 1A), then fit to the underside of the babywalker
base (Fig. 1B). Push the two front wheels R2 down hard into the housing on the base of the
babywalker (Fig. 1C).
IMPORTANT: Ensure that all of the wheels are fitted correctly proit to use.
To open the baby walker hold down the lower ring and pull up on the tray until locked in to one of
2
the three avaiable positions, as illustrated, (to lower refer to the instructions as shown in (Fig. 9).
Insert the seat padding as illustrated, and fit parts B into slots within the baby walker rim (3A).
3
IMPORTANT! It maybe necessary to use pressure to guide the U rings through the slots wthin the
upper rim. To remove the seat unit padding follow these instruction in reverse sequence.
4 WARNING! Ensure that all of the U rings, part "B" are securely fitted within the slots before use,
to eliminate any potential accident risk to your baby.
Insert rattle "C" the housing within the tray top, paying particular attention to the direction, as
5
shown in Fig 5A. Once the rattle has been inserted into the tray twist to fix into the locked position.
The activity section requires two AA alcaline batteries (not supplied). To fit or remove the batteries
6
proceed as illustrated: Press down on lever "D" and rotate cover "E" until it can be completely
removed. Insert or remove the batteries as required and then replace the cover by following the
above instructions in reverse order.
IMPORTANT: It will only be possible to gain access to the battery cover when the activity centre
is not fitted within the babywalker tray.
· Attention! The batteries must only be changed by an adult.
· Keep batteries away from children at all times.
· Use only the recommended batteries.
· Insert the batteries correctly (noting +/- markings).
· Do not mix different types of batteries or new and old batteries.
· Do not use rechargeable batteries.
This electronic device must be recycled according to the directive 2002/96/CE.
All electrical or electronic apparatus must be correctly disposed of in collection points designated by local
authorities.
Fit the activity centre to the tray as illustrated in figure 7B
7
HOW T O ADJUST THE HEIGHT: The baby walker can be adjusted into three different height
8
position. To raise from closed position "O" to the highest position "3" simply pull upwards on the
upper ring whils holding down the base ring. WARNING! Never attempt to raise or lower the
height whisl the child is seated whitin the babywalker .
To close or lower the babywalkerinto positions 1 & 2 it is sufficient to press lever 1 followed by
9
lever 2 situaded underneath the babywalker tray.
WARNING: The babywalker does not have a locking mechanism once in the closed position.
WARNING: Never attempt to raise or lower the weight whils the child is seated within the
babywalker.
THIS PRODUCT CONFORMS TO STANDARD EN 1273 : 2005
MAINTENANCE
Do not expose the cover to sunlight for long periods.
Wash the plastic parts with warm water and soap and carefully dry all the components after.
C M Y CM MY CY CMY
· Do not recharge non- rechargeable batteries.
· Remove used batteries.
· Do not short circuit the terminals.
· Keep packaging outside the reach of children.
· Keep these instructions for future reference.
K
7