Cd Player - auna Oxford Manual Del Usuario

5. Select the correct speed for your record using the RPM selector switch.
6. Choose to turn the auto stop for the turntable on or off, as required.
7. Use the tone arm lever to lift the tone arm.
8. Move the tone arm across to your record.
9. Use the tone arm lever to gently lower the stylus onto the groove on
your record. Your record will begin to play.
10. Use the large right hand rotary control to adjust the volume.
11. At the end of the record; if you have selected auto stop on, the turntable
will stop turning automatically, if you have selected auto stop off the
turntable will continue to turn until you change the mode or switch the
product to Standby mode.
12. Use the tone arm lever to lift the tone arm.
13. Move the tone arm across to the rest position.
Suspend play
To temporarily suspend playing your record.
1. Use the tone arm lever to lift the tone arm and stylus from the record.
2. To resume play, use the tone arm lever to gently lower the stylus onto
your record again.

CD PLAYER

Check that your Retro Turntable is in CD mode. If you are not already in CD
mode, repeatedly short press the Source button until you are in CD mode
(check the display). The display will show 'Cd', followed by '- - -'. If the CD
compartment is empty 'N0' will then be displayed.
Play a CD
Note: It is not possible to play DVD or computer CDs.
1. Short press the . button to open the CD drawer. 'OPEN' will be
displayed..
2. Place an audio CD, label side up, onto the CD tray. Please ensure that the
CD is laying flat within the recessed CD shaped area on the tray.
3. Short press the . button. The CD drawer will close, '- - -' will be
displayed and after a short delay the first track will begin to play; the
elapsed time of the track will be displayed.
EN
Tonarmsicherung
Tone arm clip
Protective
Nadelschutz
cover
35