Intended Use; Charging Procedure; Charging Indicator - Ratio AR144NM Manual De Instrucciones

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic..

CHARGING PROCEDURE

1. CHARGING YOUR BATTERY PACK
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot. Allow time for
the battery to cool down before recharging.
2. 1 HOW TO CHARGE THE BATTERY(FOR
AR144-2NM) (SEE FIG. A1)
1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, the
light will turn to red to indicate the charging
process has started.
3) When charging is completed, the light will
turn to green. The pack is now fully charged,
unplug the charger and remove the battery
pack.
A1
WARNING:When battery charge runs out
after continuously use or exposure to
direct sunlight or heat, allow time for the tool
to cool down before re-charging to achieve
the full charge.
42

CHARGING INDICATOR

This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center. If the new
battery pack displays the same problem as the
original Battery Pack, have the charger tested at
an authorized service center.
Light ON/OFF
flash
Red on
Red flash - - - -
Green on
Green flash - - - -
2.2 HOW TO CHARGE YOUR BATTERY (FOR
AR144-2NM)(SEE A2, A3)
1).Plug the charger into an appropriate outlet.
2).Place the battery pack into the charger
3).When charging is completed, unplug the charger
and remove the battery pack.
Note: If the battery pack is locked in the
charger, press the battery pack release button
and remove it.
WARNING:When battery charge runs out
after continuous use or exposure to
direct sunlight or heat, allow time for the tool
to cool down before re-charging
to achieve the full charge.
A2
Status
Charging
Defective Bat-
tery
Fully Charged
Hot/Cold Delay