Overload Protection; Temperature Dependent Overload Protection - Ratio AR144NM Manual De Instrucciones

I
8. USING THE SIGHT LIGHT
To turn on the light, press the on/off switch and
make sure the forward/reverse rotation control is
on right/left position. When you release the on/off
switch, the light will be off.
LED lighting increases visibility-great for dark or
enclosed area.
LED is also a battery capacity indicator. It will
flash when power gets low.
9. BATTERY CAPACITY INDICATION
Your tool is equipped with Battery Capacity
Indication (11). Press the On/Off Switch halfway
or fully, the Battery Capacity Indication will light
up to show the amount of charge left in the
battery.
Fuel Gauge
3 lights
2 lights
1 light
1 flashing light
10. BELT HOOK (SEE FIG. J1, J2)
Screw the Belt Hook (7) on the tool with the
screw provided in the plastic bag. The Belt Hook
can be hooked on your belt or pocket, etc.
J1
Capacity
> 2/3
> 1/3
< 1/3
Recharge battery
J2
11. DRILLING
When drilling into a hard smooth surface, use a
center punch to mark the desired hole location.
This will prevent the drill bit from slipping off
center as the hole is started.
Hold the tool firmly and place the tip of the bit at
the point to be drilled.
Depress the switch trigger to start the tool.
Move the drill bit into the workpiece, applying
only enough pressure to keep the bit cutting. Do
not force or apply side pressure to elongate a
hole.
If you want to activate the drill function (For
drilling metal wood or plastic), turn the torque
adjustment ring on the drill position.
Tungsten carbide drill bits should always
be used for concrete and masonry.
When drilling in metal, only use HSS drill bits
in good condition. Always use a magnetic
bit holder (not included) when using short
screwdriver bits. When screw-driving, apply a
small quantity of liquid soap or similar to the
screw threads to ease insertion.

12. OVERLOAD PROTECTION

When overloaded, the motor comes to a stop.
Relieve the load on the machine immediately and
release the on/off switch. Then you can restart
the tool soon.
13. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool
cannot be subject to overload. When the load
is too high or the allowable battery temperature
is too hot, the electronic control switches off the
power tool until the temperature is in the optimum
temperature range again.
14. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep
discharging by the "Discharging Protection
45