Braun Allstyle 5602 Manual Del Usuario página 8

may choose between six settings (approx. 0.5 / 3 / 6 / 9 /
12 / 16 mm).
• It is advisable to begin with the highest setting and then
reduce the setting until you reach the desired beard length.
• Hold the distance comb with the angled edge against your
beard and guide the trimmer against the direction of hair
growth.
• To avoid clogging the distance comb with hair, clean it from
time to time with the brush. Please note that the distance
comb can only be taken off, when the trimmer is turned off
(position «0»).
C Hair cutting
• The hair should be clean, well combed, tangle-free and dry.
• Proceed as described under (B), but using the larger distance
comb (settings approx. 10 /12 / 15 / 18 / 21 / 25 mm). If you
are not used to clipping hair, begin with a higher setting
and then reduce the setting to avoid cutting more hair than
desired. If you want to cut your hair shorter than 10 mm, we
advise to first cut it with the larger distance comb down to
10 mm and then use the smaller distance comb for the
desired length.
• Use a slow and controlled movement. Do not force the
appliance through the hair faster than it can be cut.
• In between, shake or blow off the hair. If too much hair is
caught in the distance comb, remove and clean it. Please
note that the distance comb can only be taken off, when the
trimmer is turned off (position «0»).
D Contour trimming
• To use the contour trimmer, take off the distance comb
(trimmer turned off, position «0»).
• For precision contouring, tilt the system so the narrow
trimmer (= contour trimmer (3b)) shows upward.
• The contour trimmer is ideal for precisely outlining beard
contours, shaping partial beards, trimming hair lines and also
for removing long single hairs.
• To trim larger outlines, make sure the beard trimmer (3a)
shows upward.
• Avoid jerky movements while trimming.
Keeping your Allstyle in top shape
E Cleaning and care
• After each use, take off the distance comb and slightly shake
or brush hair from the appliance and the distance comb(s).
• Press the release buttons to lift off the twin cutter system.
8