STERWINS ETHT2-50.3 Manual De Instrucciones página 223

Operation
1. Adjust the pole to required length as described in the assembly
manual.
2. Before trimming the hedge, cut and remove branches exceeding the
cutting capacity of this product using a proper pruner.
3. Always hold the product firmly with both hands on gripping surface
and handle. Never operate this product using only one hand.
4. Cut both sides from the bottom cutting upwards to the top. This will
prevent any of the cuttings falling into the path of the area still to be
cut.
5. After cutting the sides proceed to the top.
6. When cutting wide hedges with the cutting area in sight, move the
cutting blade lightly through the cutting surface in a sweeping motion
following the shape of the hedge or shrub. A slight tilt downwards
of the cutting blade in the direction of motion is recommended for
optimum cutting performance.
7. Move the product slowly forward when cutting higher hedge and the
cutting area out of sight.
8. Do not rush and do not attempt to cut too much with one stroke of the
cutting blade.
9. Cut in a number of stages if the area being cut is particularly long to
achieve a better result; smaller cuttings will allow for easy composting.
4.TECHNICAL SPECIFICATIONS
223
EN