Mounting On A Tripod - Dörr MVL-77 Manual De Instrucciones

05 | OPERATION
Press the On/Off/Menu button
(08) shows the remaining battery power in h (hours) or m (minutes). The battery symbol shows the battery capacity graphically:
Press On/Off/Menu button
shows the selected menu point in the display (08):
Brightness
Press the button (11) to increase the brightness and colour temperature.
Press the button (09) to decrease the brightness and colour temperature.
Brightness is adjustable in 1% steps, while colour temperature is adjusted in 100° Kelvin steps.
Press On/Off/Menu button
CAUTION:
·
During operation, the housing and LEDs will warm up.
·
Turn off the device after usage by using On/Off/Menu button (10).
·
Let the device cool down completely, before placing it in the storage pouch.
06 | MOUNTING

06.1 Mounting on a tripod

For mounting on a tripod, screw the LED video light onto your tripod either using the ¼ inch tripod mount (05a) at the bottom of the
magnetic screw (05) or with the ¼ inch tripod mount (04a) below the universal hot shoe mount (04). Suitable tripods are optionally
available from DÖRR.
06.2 Attachment to magnetic surfaces
Thanks to the magnetic screw (05) you can attach the LED video light to all magnetic surfaces.
06.3 Mounting on camera/camcorder with hot shoe
To mount the LED video light on a camera or camcorder with a hot shoe, first unscrew the magnetic screw (05). Now you can slide
the universal hot shoe mount (04) into the hot shoe of your camera or camcorder. Tighten the locking screw (03) downwards.
10
(10) for about 2 seconds in order to turn on the LED video light. During operation, the display
(10) shortly to switch from brightness
(10) for about 2 seconds in order to turn off the video light.
to colour temperature
Colour Temperature
and back. The symbol
doerr-foto.de