Marshalltown Bullet BT92-2195 Manual Del Usuario página 5

ASSEMBLY
1. Open table
2. Remove cutting unit
3. Attach cutting unit to table
using provided knobs
Edges cut with the Bullet Cutter
are square on one board and
beveled on the other.
1. Lift handle fully
2. Insert flooring plank
3. Push handle down firmly
SHEAR PIN SAFETY FEATURE
Your Bullet Vinyl Cutter is equipped with a shear pin which will snap if too much pressure is applied to the
handle. This is to prevent damage to other components of your cutter.
If you press too hard on the handle and snap the shear pin, remove the pieces and replace it with the spare
shear pin with the push-on retaining ring (included with your cutter, look inside the carry-case/table)
5 of 10
WS2639
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com