Inserting The Inside Cover; Operating The System - S&P PULSE 160 Manual De Instrucciones

Ocultar thumbs Ver también para PULSE 160:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Start by connecting the two units. This is done by
sliding the fan unit over the front end of the heat
exchanger unit. Then insert the two into the moun-
ting tube (2), with the insect fi lter facing outwards.
EN
Push the unit carefully into the mounting tube until
it touches the outside cover.
The strap must point inwards (towards
the room), allowing the heat exchan-
ger to be removed for maintenance.

5.6. INSERTING THE INSIDE COVER

Once all work inside the building has been com-
pleted, the inside cover can be installed. Place the
fi lter unit in the slots for the fi lter inside the cover.
Insert the cover into the mounting tube, making
sure that the air vent points upwards and that the
cover sits tightly.
The units must have a fi lter inserted
before being turned on for the fi rst
time.

6. OPERATING THE SYSTEM

6.1. PULSE 160
The inside cover can be shut, should you not use
the system over a longer period or should you want
to prevent smoke for instance entering the room.
Do not operate the system when the
inside cover is shut!
6.1.1. Shutting the inside cover
Step 1: Pull the inside cover out of the mounting
tube.
20
Step 2: Use the fl ap attached to the inside of the
cover.
Step 3: Press the fl ap into the fl exible foam until
it sits tightly.
Step 4: Reinsert the inside cover into the mounting
tube.
6.1.2. Opening the inside cover
Step 1: Pull the inside cover out of the mounting
tube.
Step 2: Pull the fl ap out of the fl exible foam.

Publicidad

Tabla de contenido
loading

Tabla de contenido