Jensen MP1514BT Manual Del Propietário página 9

9. To further secure the unit, use the supplied metal strap to secure the back of
the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring
Washer) to attach one end of the strap to the mounting bolt on the back of
the unit. If necessary, bend the metal strap to fit your vehicle's mounting area,
then use the supplied hardware (Tapping Screw and Plain Washer) to attach
the other end of metal strap to a solid metal part of the vehicle under the
dashboard. This strap also helps ensure proper electrical grounding of the
unit.
Note: Install the short threading terminal of the mounting bolt to the back of
the unit and the other long threading terminal to the dashboard.
(1) Metal Strap; (2) Mounting Bolt;
(3) Hex Nut; (4) Spring Washer;
(5) Tapping Screw; (6) Plain Washer
10. Reconnect the cable to the vehicle battery's negative (-) terminal.
11. Replace the outer trim ring.
12. Install the unit's faceplate (see "Installing the Faceplate").
MP1514BT
9