HoMedics enviraScape WFL-TRTW Manual De Instrucciones Y Garantía página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth. (Fig 1)
Figure 1
Top
(1) Upper Ring
(1) Upper Leg with cord clip
(2) Upper Leg
(1) Screwdriver
(1) Leg Holder
(6) Screws in Leg Holder
(6) Screws
(2) Bottom Leg
(1) Bottom Leg with cord clip
4
Assemble the fountain stand:
2.
NOTE: For easy reference, each leg is labeled.
a. Place the Bottom Ring on a flat surface allowing the
ring to slightly hang over for easy alignment and
tightening of screws as shown in Figure 2. Align the
holes of the Bottom Ring with the holes on the
Bottom Legs and PARTIALLY secure by tightening
the screws using the screwdriver provided. Repeat
until all three of the Bottom Legs are partially
secure. (Fig 2)
NOTE: DO NOT tighten completely at this point.
Base
b. Insert the Bottom Legs into the Leg Holder and
adjust so they sit evenly. Now, completely tighten
Base Cord
the three screws in the Leg Holder and the three
screws in the Bottom Ring . (Fig 3)
NOTE: Before inserting legs, you may need to
unscrew the screws from the Leg Holder to allow
for the legs to slide in the holder properly.
Adaptor
c. Insert the Upper Legs into the other end of the
Leg Holder.
NOTE: The Bottom Leg with the cord clip should
be positioned on the same side of the Leg Holder
as the Upper Leg with the cord clip. DO NOT
tighten screws in Leg Holder at this point. (Fig 4)
(1) Bottom Ring
Figure 2
Bottom Legs
Bottom Ring
Figure 3
Leg Holder
Bottom Legs
Bottom Ring
Figure 4
Upper Legs
Cord
Clips
Leg Holder
Bottom Ring
5

Publicidad

Tabla de contenido
loading

Tabla de contenido